VEGACAP 63 is a compact instrument, i.e. it can be operated withoutexternal evaluation system. The integrated electronics evaluates thelevel signal and outputs a switching signal. With this switching signal, aconnected device can be operated directly (e.g. a warning system, aPLC, a pump etc.).The data for power supply are specified in chapter "Technical data".3.3 OperationThe probe can be adapted to the dielectric constant of the productdirectly on the electronics module.A switching command can be triggered when the probe is covered orlaid bare.On the electronics module you will find the following indicating andadjustment elements:l Signal lamp for indication of the switching condition (green/red)l Potentiometer for switching point adaptationl DIL switch for measuring range selectionl DIL switch for mode adjustment3.4 Storage and transportYour instrument was protected by packaging during transport. Itscapacity to handle normal loads during transport is assured by a testaccording to DIN EN 24180.The packaging of standard instruments consists of environment-friendly, recyclable cardboard. For special versions, PE foam or PE foilis also used. Dispose of the packaging material via specialisedrecycling companies.Transport must be carried out under consideration of the notes on thetransport packaging. Nonobservance of these instructions can causedamage to the device.The delivery must be checked for completeness and possible transitdamage immediately at receipt. Ascertained transit damage orconcealed defects must be appropriately dealt with.Up to the time of installation, the packages must be left closed andstored according to the orientation and storage markings on theoutside.Unless otherwise indicated, the packages must be stored only underthe following conditions:l Not in the openl Dry and dust freel Not exposed to corrosive mediaPower supplyPackagingTransportTransport inspectionStorageVEGACAP 63 • - Relay (DPDT) 93 Product description30008-EN-090604