The new oscillator must contain the order data of the sensor.These can be loaded as follows:l At the factory by VEGAl Or on site by the userInformation:When loading on site, first of all the order data must bedownloaded from the Internet (see operating instructionsmanual "Oscillator").In both cases, the serial number of VEGAFLEX 62 is required.The serial numbers are stated on the type label of VEGAFLEX62, on the inner wall of the housing or on the delivery note.The oscillators are adapted to the respective sensor and differin their signal output or in their power supply. You can find asuitable oscillator in the following overview.Electronics module FX-E.60V suitable for VEGAFLEX 61, 62,63 - 4 … 20 mA/HART four-wire:l FX-E.60VX (X = without approvals)l FX-E.60VA (A = approval DA according to product list)l FX-E.60VC (C = approvals DX, EX, GX according toproduct list)8.5 Instrument repairIf a repair is necessary, please proceed as follows:You can download a return form (23 KB) from our Internethomepage www.vega.com under: "Downloads - Forms andcertificates - Repair form".By doing this you help us carry out the repair quickly andwithout having to call back for needed information.l Print and fill out one form per instrumentl Clean the instrument and pack it damage-proofl Attach the completed form and, if need be, also a safetydata sheet outside on the packagingl Please ask the agency serving you for the address of yourreturn shipment. You can find the respective agency on ourwebsite www.vega.com under: "Company - VEGA world-wide"On instruments with exchangeable rod, the rod must beunscrewed for transport to avoid damages.Return the parts separately for repair.Assignment4 … 20 mA/HART four-wireReturn of rod versionsVEGAFLEX 62 • 4 … 20 mA/HART - four-wire 438 Maintenance and fault rectification31838-EN-080826