Vega VEGAFLEX 65 Operating Instructions Manual

Also see for VEGAFLEX 63: Operating instructions

Vega VEGAFLEX 65 Operating Instructions Manual Manual pdf 13 page image

Keep in mind that a min. distance must be maintained belowthe reference plane and possibly also at the end of the probe -measurement in these areas is not possible. These min.distances are listed in chapter "Technical data" in the"Supplement".The process fitting must be sealed if there is gauge or lowpressure in the vessel. Before use, check if the seal material isresistant against the measured product and the processtemperature.The max. permissible pressure is specified in chapter"Technical data" or on the type label of the sensor.4.2 Mounting instructionsMount VEGAFLEX 65 in such a way that the probe does nottouch any installations or the vessel wall during installation.In vessels with conical bottom it can be advantageous tomount the sensor in the center of the vessel, as measurementis then possible down to the lowest point of the vessel bottom.Fig. 3: Vessel with conical bottomMake sure that the probe is not subjected to strong lateralforces. Mount VEGAFLEX 65 at a position in the vessel whereno disturbances, e.g. from filling openings, agitators, etc., canoccur.PressureMounting positionInflowing mediumVEGAFLEX 65 • 4 … 20 mA/HART 134 Mounting31845-EN-080716