Vega VEGAFLEX 81 Operating Instructions Manual

Also see for VEGAFLEX 81: Mounting instructions Quick setup guide Operating instructions Operating instructions Operating instructions

Contents

Vega VEGAFLEX 81 Operating Instructions Manual Manual pdf 15 page image

154 MountingVEGAFLEX 81 • 4 … 20 mA/HART - four-wire42280-EN-160518You can find detailed information on the process conditions in chapter"Technical data" as well as on the type label.4.2 Mounting instructionsIn vessels with conical bottom it can be advantageous to mount thesensor in the center of the vessel, as measurement is then possiblenearly down to the lowest point of the bottom. Keep in mind thatmeasurement all the way down to the tip of the probe may not be pos-sible. The exact value of the min. distance (lower dead band) is statedin chapter "Technical data".Fig. 4: Vessel with conical bottomBefore beginning the welding work, remove the electronics modulefrom the sensor. By doing this, you avoid damage to the electronicsthrough inductive coupling.Do not mount the instruments in or above the filling stream. Make surethat you detect the product surface, not the inflowing product.Installation positionWelding workInflowing medium

/ 80

Related manuals for Vega VEGAFLEX 81

Vega VEGAFLEX 81 Operating Instructions Manual

This manual is suitable for:

VEGAFLEX 81

manualsdatabase

Your AI-powered manual search engine