Vega VEGAPULS 61 Quick Setup Manual

Also see for VEGAPULS 61: Operating instructions Quick setup guide Operating instructions Operating instructions Operating instructions

Contents

Vega VEGAPULS 61 Quick Setup Manual Manual pdf 13 page image

135 Set up with the display and adjustment module PLICSCOMVEGAPULS 61 • Profibus PA51870-EN-1802223. Confirm "False signal suppression - Change now" with [OK] andselect in the below menu "Create new". Enter the actual distancefrom the sensor to the product surface. All false signals in thisarea are detected by the sensor and saved after confirming with[OK].Note:Check the distance to the product surface, because if an incorrect(too large) value is entered, the existing level will be saved as a falsesignal. The level would then no longer be detectable in this area.5.3 Menu schematicInformation:Depending on the version and application, the highlighted menuwindows may not always be available.Basic adjustment▶ Basic adjustment 1DisplayDiagnosticsServiceInfoSensor address 1.1126Min. adjustment 1.20.00 %=10.000 m(d)8.000 m(d)Max. adjustment 1.3100.00 %=1.000 m(d)2.000 m(d)Medium 1.3not known ▼Vessel form 1.4not known ▼Linearisation curve 1.6LinearChannel 1.7PV lin. valueDamping 1.80 sSensor-TAG 1.9SensorDisplayBasic adjustment 2▶ DisplayDiagnosticsServiceInfoDisplayed value 2.1PA-OutBacklight 2.4Switched off ▼