366 Set up with the display and adjustment moduleVEGAPULS 62 • HART and accumulator pack40793-EN-170405When the [+] and [->] keys are pressed quickly, the edited value,or the cursor, changes one value or position at a time. If the key ispressed longer than 1 s, the value or position changes continuously.When the [OK] and [ESC] keys are pressed simultaneously for morethan 5 s, the display returns to the main menu. The menu language isthen switched over to "English".Approx. 60 minutes after the last pressing of a key, an automatic resetto measured value indication is triggered. Any values not confirmedwith [OK] will not be saved.6.3 Measured value indication - Selection ofnational languageWith the [->] key you move between three different indication modes.In the first view, the selected measured value is displayed in largedigits.In the second view, the selected measured value and a correspond-ing bar graph presentation are displayed.In the third view, the selected measured value as well as a second se-lectable value, e.g. the temperature of the electronics, are displayed.During the initial setup of an instrument shipped with factory settings,use the "OK" key to get to the menu "National language".This menu item is used to select the national language for further pa-rameter adjustment. You can change the selection via the menu item"Setup - Display, Menu language".With the "OK" key you move to the main menu.6.4 Parameter adjustmentThe instrument is adapted to the application conditions via the pa-rameter adjustment. The parameter adjustment is carried out with anadjustment menu.The main menu is divided into five sections with the following func-tions:Setup: Settings, e.g., for measurement loop name, medium, applica-tion, vessel, adjustment, signal outputTime functionsMeasured value indica-tionSelection of nationallanguageMain menu