Vega VEGAPULS 62 Quick Setup Manual

Also see for VEGAPULS 62: Operating instructions Safety manual Quick setup guide Operating instructions Operating instructions

Contents

Vega VEGAPULS 62 Quick Setup Manual Manual pdf 11 page image

114 Connecting to power supplyVEGAPULS 62 • 4 … 20 mA/HART - four-wire47121-EN-1602156. Check the hold of the wires in the terminals by lightly pulling onthem7. Connect the screen to the internal ground terminal, connect theouter ground terminal to potential equalisation in case of powersupply via low voltage8. Connect the lead cable for power supply in the same way accord-ing to the wiring plan, in addition connect the ground conductor tothe inner ground terminal when powered with mains voltage.9. Tighten the compression nut of the cable glands. The seal ringmust completely encircle the cables10. Screw the housing lid back onThe electrical connection is finished.Information:The terminal blocks are pluggable and can be removed from thehousing insert. To do this, lift the terminal block with a small screwdriv-er and pull it out. When inserting the terminal block again, you shouldhear it snap in.4.2 Wiring plan, double chamber housingThe following illustrations apply to the non-Ex as well as to the Ex-d-iaversion.power supply4...20mAactivepassivecommonIS GND51/L/NPE2+( ) (-) 6 7 8Fig. 6: Connection compartment with double chamber housing with mainsvoltageTerminal Function Polarity1 Voltage supply +/L2 Voltage supply -/N5 4 … 20 mA output (active) +6 4 … 20 mA output (passive) +7 Mass - output -8 Function ground when in-stalling according to CSA(Canadian Standards Asso-ciation)Connection compartmentwith mains voltage