Up to the time of installation, the packages must be left closed andstored according to the orientation and storage markings on theoutside.Unless otherwise indicated, the packages must be stored only underthe following conditions:l Not in the openl Dry and dust freel Not exposed to corrosive medial Protected against solar radiationl Avoiding mechanical shock and vibrationl Storage and transport temperature see chapter "Supplement -Technical data - Ambient conditions"l Relative humidity 20 … 85 %3.4 Accessories and replacement partsThe indicating and adjustment module PLICSCOM is used formeasured value indication, adjustment and diagnosis. It can beinserted into the sensor and removed at any time.You find further information in the operating instructions "Indicating andadjustment module PLICSCOM" (Document-ID 27835).The interface adapter VEGACONNECT 4 enables the connection ofcommunication-capable instruments to the USB interface of a PC. Forparameter adjustment of these instruments, an adjustment softwaresuch as PACTware with VEGA-DTM is required.You can find further information in the operating instructions "Interfaceadapter VEGACONNECT" (Document-ID 32628).VEGADIS 61 is suitable for external measured value indication andadjustment of plics® sensors. It is connected to the sensor with an upto 50 m long, four-wire, screened standard cable.You can find further information in the operating instructions"VEGADIS 61" (Document-ID 27720).VEGADIS 62 is suitable for measured value indication and adjustmentof sensors with HART protocol. It is looped into the 4 … 20 mA/HARTsignal cable.You can find further information in the operating instructions"VEGADIS 62" (Document-ID 36469).The protective cover protects the sensor housing against soiling andintense heat from solar radiation.StorageStorage and transporttemperatureIndicating and adjust-ment moduleInterface adapterExternal indicating andadjustment unitProtective cap10 VEGAPULS 63 • 4 … 20 mA/HART two-wire3 Product description36511-EN-091023