Vega VEGAWAVE 63 Operating Instructions Manual

Also see for VEGAWAVE 63: Operating instructions Operating instructions Operating instructions Operating instructions Operating instructions

Vega VEGAWAVE 63 Operating Instructions Manual Manual pdf 17 page image

3 Remove approx. 10 cm (4 in) of the cable mantle, stripapprox. 1 cm (0.4 in) insulation from the ends of theindividual wires4 Insert the cable into the sensor through the cable entry5 Lift the opening levers of the terminals with a screwdriver(see following illustration)6 Insert the wire ends into the open terminals according tothe wiring plan7 Press down the opening levers of the terminals, you willhear the terminal spring closing8 Check the hold of the wires in the terminals by lightlypulling on them9 Tighten the compression nut of the cable entry. The sealring must completely encircle the cable10 If necessary, carry out a fresh adjustment11 Screw the housing cover back onThe electrical connection is finished.Fig. 8: Connection steps 5 and 65.3 Wiring plan, single chamber housingThe following illustrations apply to the non-Ex as well as to theEEx d version.VEGAWAVE 63 - - NAMUR 17Connecting to voltage supply32259-EN-070117