14620. Safety cabin (optional)20.1 Setting up the safety cabinWhen mounting the safety cabin to a WABECO tool cabinet, the appropriate bored holes are alreadypresent. The tool cabinet ensures a safe base for the milling machine or safety cabin.If the safety cabinet is secured to another suitable surface, the 4 through holes must be bored into thesurface by the client. For the positions of the 4 fixture threaded sockets (thread M8) of the safetycabinet, see diagram. The diameter of the through holes in the surface must be at least 9 mm.20.2 Mounting of the safety cabin to the tool cabinet(optional)■ The safety cabinet (2) is positioned, as shown, on the tool cabinet (1).■ The screws and washers required for assembly are included in the scope of delivery.To screw the safety cabinet to the tool cabinetproceed as follows:1. Combine each screw with a washer2. Open the door or the tool cabinet3. Push the screws from below, through the bored holes in the tool cabinet, into the fixture threadedsockets and tighten using a Allen key of size 6.
