WAGNER GM 2800EA Operating Manual

Also see for GM 2800EA: Operating manual

WAGNER GM 2800EA Operating Manual Manual pdf 37 page image

37GM 2800EA$ % ! "#&"?OPERATING MANUALEDITION 03/ 2007 PART NO. DOC3888918.5 REPLACING THE PAINT HOSE1. Unscrew nut (A) using the universal spanner.2. Pull material hose (B) out of the connection (C).3. Remove insert (D), clamping ring (E) and nut (A) from material hose.4. Pull the material hose back through the protective sleeve (F) and remove it.If the material hose has been ordered per meter, strip the insulation from 75 mm; 3.0inch at both ends. Pay attention not to damage the hose.5. Push the new material hose (without union nut and clamping ring) through theprotective sleeve (F).6. Fit the nut (A) and clamping ring (E) over the material hose (B).7. Insert the cleaned or new sealing sleeve (D) into the material hose (B).8. Wet the material hose (B) on the insert length with insulating oil (castor oil).NoteThe high-voltage oil protects against high-voltage burn through (leakage to earth oratmosphere).9. Insert material hose (B) into the connection (C) as far as it will go.10. Pull the union nut (A) over the clamping ring (E) and gently tighten it with the universalspanner.Mounting with insulating oilWARNINGDamaged material hose!Risk of injury from coating material coming outElectric shock risk When removing insulation, ensure that the inner hose is notdamaged.SIHI_0036_GB