13OPERATING MANUALVERSION 02/2013 ORDER NUMBER DOC 23335484.2.1 SAFE HANDLING OF WAGNER SPRAY DEVICESThe spray jet is under pressure and can cause dangerous injuries.Avoid injection of paint or cleaning agents:Never point the spray gun at people.Never reach into the spray jet.Before all work on the device, in the event of work interruptions and functional faults:- Switch off the energy/compressed air supply.- Relieve the pressure from the spray gun and device.- Secure the spray gun against actuation.In the event of functional faults: remedy the fault as described in the "Trouble Shooting"chapter.The liquid emitters are to be checked for safe working conditions by an expert (e.g.Wagner Service Technician) as often as necessary or at least every 12 months, inaccordance with the guidelines for liquid emitters (ZH 1/406 and BGR 500 Part 2Chapter 2.36).– For shut down devices, the examination can be suspended until the next start-up.Carry out the work steps as described in the "Pressure Relief / Work Interruptions"chapter:– if pressure relief is required.– if the spraying work is interrupted or stopped.– before the device is cleaned on the outside, checked or serviced.– before the spray nozzle is installed or cleaned.In the event of skin injuries caused by paint or cleaning agents:Note down the paint or cleaning agent that you have been using.Consult a doctor immediately.Avoid danger of injury through recoil forces:Ensure that you have firm footing when operating the spray gun.Only hold the spray gun briefly in a position.4.2 SAFETY INSTRUCTIONS FOR STAFFAlways follow the information in these instructions, particularly the general safetyinstructions and the warning instructions.Always follow local regulations concerning occupational safety and accident prevention.