20General instructions 20Preparation 20Fire Safety 21Installation 21Repairs 22Technical details Domus / Luna Petite 23Installation InstructionsGeneral instructionsThe Domus and the Luna Petite are tested in accordancewith international EN13240 standardisation and haveextra additional standardization for optimal environment-friendly heating devices related to flue gases (Section15a B-Vg. Des BmfWA).The stove can be connected to a flue tube to whichseveral stoves are connected. The shove should never beintegrated into the wall. The stove must be installed byan acknowledged installer lest the guarantee lapsesThe heating device must be placed by an acknowledgedinstaller and according to the installation instructionsgiven below. The national and local rules and regulationsfor placing and using wood-burning stoves are equallyapplicable. WANDERS does not give any guaranteeif the stove is connected or installed incompletely orincorrectly.It is not allowed to place the stove in:• Arcades and corridors accessible to the public.• Stairwells, except in buildings with no more than 2dwellings.• Spaces where highly flammable or explosive materialsare used.• Spaces where an exhaust system is used or where amechanical exhaust system is placed, except whenthe air supply is taken directly from outside to assurea hazardless combustion.PreparationThe chimney flueBefore placing the stove you must observe the followingpoints:• If the stove is connected to an existing chimney, youmust first have the chimney professionally cleanedand checked by a qualified chimney sweep company.Any cut-off valves or stop valves must be removed.• The flue tube of the stove must be connected with thechimney without diversions.• The underpressure in the chimney must be at least 12Pa or 0.12 mbar.• The chimney flue must always end up in outlet area 1(see the drawing and the table below)Roof slope x larger than 23°Roof slope x smaller than 23°• At the time of placing the stove, the chimney fluemust be clean, leak-proof and without obstructions,and must have a diameter of 150 mm.• Any bends in the flue tube must not exceed 45degrees.