WANDERS Stealth User Manual And Installation Manual

Also see for STEALTH - SCHEMATICS: Manual Instructions for use intallation manual

WANDERS Stealth User Manual And Installation Manual Manual pdf 21 page image

21GBTIMER button to save the pre-set time.Setting in Fahrenheit or CelsiusThe display starts blinking after placing the batteries, or after simultaneously pressing the buttons AUTOand TIMER. When the display is still blinking, you can switch from Fahrenheit / 12-hour indication to Celsius/ 24-hour indication. The indication will switch when pressing the AUTO button. The display will switchautomatically to manual operation after some timeSetting the desired temperaturePress and hold the AUTO button until the TEMP indication blinks. You can set a higher temperature with the button and a lower temperature with the  button. Then wait a few seconds, or press the AUTO button toswitch to the automatic modus.Checking the set temperatureBriefly press the AUTO button. The display briefly shows the pre-set temperature and then displays the roomtemperature.TIMERYou can pre-set a total of four time-settings. When you link up all four time-settings, you can be sure of acomfortable room temperature at all times.Press and hold the TIMER button until the indication P1<> blinks. With the  and  buttons you can setrespectively the hours and the minutes. By briefly pressing the TIMER button you can browse through thetimer programme P1<>, P1<>, P2<> and P2<>. Here is an example of a possible pre-setting.P1<>-temp: 07:30 - 08:30 the pre-set temperatureP1<>-temp: 08:30 - 17:00 offP2<>-temp: 17:00 - 23:00 the pre-set temperatureP2<>-temp: 23:00 - 07:30 offThe TIMER function works only when the pilot flame is on. If the TIMER mode is switched on, the temperaturecontrol will be the same as in the AUTO position. You can switch off the TIMER mode with the  and buttons. The remote control will automatically switch to the MAN function.MANWhen the display shows the MAN position you can manually turn the hearth higher  and lower  by usingthe big buttons. When you press and hold the  button the hearth will go to its lowest position: the pilotflame. When you keep these buttons pressed, you will see the ‘transmit’ symbol top left in the display. You willknow when the hearth has reached its highest or lowest position when the LED of the receiver starts blinking.MaintenanceSmall maintenanceYou can clean the outside of the hearth with a damp cloth that doesn’t give off fluff. Only clean the outsidewhen the hearth is cold. If some coffee is spilled on the unit when it is burning, turn the hearth off immediately.When the hearth has cooled off completely, you can remove any stains with a damp clothDo not use any aggressive cleansing agents or abrasives and do not use stove polish.Annual maintenanceYour gas hearth needs to be checked and maintained by a certified installer at least once a year. He will checkand, if necessary, clean the following components:!