1wibenchmfg.com 507 E . Grant St. Thorp, WI 54771 • P - 800.242.2303Speciflcations are subject to change. Productimages are for illustrative purposes only and maydifier from the actual product.To o l s R e q u i r e d• 4mm Hex Wrench• Screw Gun• # 2 PhillipsStep 1:• Place TORO frame down on a clean and flat surface with tabsfacing up.Step 2:• Place both of the scissor jacks down on the middle cross baraligning with the pre-drilled pilot holes.• Using a # 2 Phillips, secure the scissor jacks to the middle framewith four, 8-32 x 1/2” flat head machine screws.Step 3:• Place both of the TORO tops facing down on a protected flatsurface so pre-drilled pilot holes are facing up. See images tothe right and below for the proper placement for each of thetops.Step 4:• Place TORO frame that you just assembled in Steps 1-2, downon the TORO tops and align with the pre-drilled pilot holes withthe three tabs, scissor jacks and the piano hinge.• Please use image below for all eleven locations of thepre-drilled pilot holes which are marked with a red dot.Step 5:• Using a # S2 square bit, secure frame, scissor jacks and pianohinge to the table tops with #10 x 3/4” square pan screws. Youwill use one screw per tab, two screws per scissor jack and fourscrews for the piano hinge.V122320 subject to change.Step 3-5Before you begin, please make sure all parts and proper quantities are included. (See Part Identifier Key) Any parts damaged during shipment must be reportedwithin 24 hours of receipt. To report information regarding damages or if you have any questions, please call 800.242.2303.Scissor jackPiano hingeTORDT6068-ADJStep 1-2TORO Drafting TableGrey Laminate TopsAssembly InstructionsBottom View of the TableScissor jacksSmaller topTabsPiano hingeLarger top