WB Mfg ELO Assembly Instructions Manual

WB Mfg ELO Assembly Instructions Manual Manual pdf 1 page image

wibenchmfg.com 507 E. Grant St. Thorp, WI 54771 • P - 800.242.2303Specifications are subject to change. Productimages are for illustrative purposes only and maydiffer from the actual product.1To o l s R e q u i r e d• Screw gun• 4mm hex bit• 4mm Allen wrenchBefore you begin, please make sure all parts and properquantities are included. (See Part Identifier Key) Any partsdamaged during shipment must be reported within 24 hours ofreceipt. To report information regarding damages or if you haveany questions, please call 800.242.2303.V071122 Version subject to changeELO® Ingenuity TableAssembly InstructionsStep 1:• Place top face down on protected flat surface sothreaded inserts are facing up.Step 2:• Align leg with threaded inserts.• Using a 4mm Allen wrench or 4mm hex bit and ascrew gun, fasten leg to top with the 1/4"-20 x 15mmjoint connector bolts.• Repeat this for each leg.Step 3:• Adjust legs to desired height and then with someone’shelp, turn table upright.Step 4:• Align pre-drilled holes in one of the long laminate railswith the threaded inserts in the side of the top.• Using a 1/4"-20x40mm joint connector bolt, insert thebolt through the pre-drilled hole in the rail into thethreaded insert of the top. Use a 4mm Allen wrenchor a 4mm hex bit and a screw gun to fasten bolt intoplace.• After the first bolt is fastened, proceed attaching theremaining bolts in the long rail.• Repeat for the remaining three rails.Step 4Step 2

/ 2

Related manuals for WB Mfg ELO