DescriptionT01112GB.fm 184. Description4.1 ApplicationsWhen breaking up concrete and asphalt or soil that is full of boulders,for breaking off in concrete, brickwork and other building materials(overgrown or frozen ground) etc., for tearing up streets and concrete,asphalt, tar, wood and pavement, for paring clay, loam, peat and salts,for crushing soil that has been pressed by vehicles, for ramming inposts and grounding rods with the respective tools. In track laying topack ballast under railway sleepers.4.2 Transport to worksiteRequirements:∗ When transporting the Wacker machine, use only suitable hoistinggear with a minimum load-bearing capacity of 30 kg.∗ Always turn off the motor during transportation!∗ When transporting on the cargo area of a vehicle, fasten the Wackermachine.Note: Also observe the regulations in the chapter Safety information!4.3 Functional descriptionThe drive motor drives the percussion system via gears andconnecting system. The torque is transferred non-positively by thecentrifugal clutch.The drive motor works according to the two-cycle principle and isstarted mechanically via a recoil starter.Machines with remote cut-off:The machine is equipped for the connection of a remote cut-off. Forfurther information on the remote cut-off, refer to the manufacturer'soperator's manual.To operate machines without remote cut-off, the shorting plug must beplugged into the connector.