Wacker Neuson GP 3800A Operator's Manual

Also see for GP 3800A: Operator's manual Operator's manual Repair manual

Contents

Wacker Neuson GP 3800A Operator's Manual Manual pdf 28 page image

wc_tx003412gb.fm28Operation GP 3800A4.4 Recommended FuelUse ofoxygenatedfuelsSome conventional gasolines are blended with alcohol. These gasolines arecollectively referred to as oxygenated fuels. If you use an oxygenated fuel, be sureit is unleaded and meets the minimum octane rating requirement.Before using an oxygenated fuel, confirm the fuel’s contents. Some states andprovinces require this information to be posted on the fuel pump.The following is the Wacker Neuson approved percentage of oxygenates:ETHANOL - (ethyl or grain alcohol) 10% by volume. You may use gasolinecontaining up to 10% ethanol by volume (commonly referred to as E10). Gasolinecontaining more than 10% ethanol (such as E15, E20, or E85) may not be usedbecause it could damage the engine.If you notice any undesirable operating symptoms, try another service station, orswitch to another brand of gasoline.Fuel system damage or performance problems resulting from the use of anoxygenated fuel containing more than the percentages of oxygenates mentionedabove are not covered under warranty.4.5 Wheel KitThe wheel kit (Part No. 0161308) is a standard item on Item Number 0620012,0620015, 0620043 and 0620046 only. It is available as an option on all othermodels.1. Hoist the generator, and align the axle (c) with the lower cross-member offrame.2. Insert the axle brackets (k) over the axle and align the holes found in the axlebracket to the holes of the cross-member. Ensure that the brackets extendunder the tube of the frame.3. Insert M6 x 16 screws (l) through the outer holes on the cross-member, thenthrough the holes of the axle bracket.4. Insert M6 nuts (m) onto the screws and tighten. Torque to 7.5 Nm (5.25 ft.lbs.).5. Assemble the washers (g) next to the rings (h), then add the wheels (d).6. Add the washers (g) next to the wheels, then insert the pins (f) into the holes ofthe axle and separate the legs of the pins.7. Align the holes found in the leg bracket (b) to the holes of the lower cross-member.8. Insert M6 x 16 screws (l) through the outer holes on the cross-member, thenthrough the holes of the leg bracket.9. Insert M6 nuts (n) onto the screws and tighten. Torque to 7.5 Nm (5.25 ft.lbs.).10.Insert M8 x 30 screw (o) through the hole in the leg bracket and through thehole in cross-member.11.Insert M8 nut (p) onto the screw and tighten. Torque to 18.75 Nm (13.5 ft.lbs.).12.Align the holes in the rubber foot mounts (e) to the holes of the leg bracket.