Wacker Neuson WP Series Operator's Manual

Also see for WP1550A US: Operator's manual Operator's manual Operator's manual Operator's manual

Wacker Neuson WP Series Operator's Manual Manual pdf 13 page image

4 Security100_0202_si_0012.fm 134.8 General safety instructions - Combustion enginesThe following notes must be observed: Before starting work, check the engine to ensure there are no leaks and cracks in the fuel lines, tankand fuel cap. Do not operate a defective engine. Replace damaged parts immediately. The pre-set engine speed may not be adjusted. This could lead to engine damage. Make sure that the exhaust system of the engine is free of debris. Fire hazard! Switch off the engine and allow to cool before refueling. Use the correct fuel type. The fuel may not be mixed with other liquids. Use clean filling aids for refueling. Do not spill fuel. Immediately wipe up any spilled fuel. The engine may not be started near spilled fuel. Explosion hazard! For operation in partially closed spaces, sufficient ventilation and aeration must be ensured. Do notinhale exhaust fumes. Risk of poisoning! The engine surface and exhaust system can quickly become extremely hot. Risk of burns!4.9 General safety instructions – fuel, lubricants and coolantsThe following notes must be observed: Always wear safety glasses and protective gloves when handling fuel, lubricants, and coolants. Ifhydraulic oil, fuel, oil, or coolant gets into your eyes, see a doctor immediately. Avoid direct skin contact with fuel, lubricants and coolants. Immediately rinse skin with soap andwater. Do not eat or drink while working with fuel, lubricants and coolants Contaminated hydraulic oil or fuel from dirt or water can lead to premature wear or failure of themachine Dispose of spilled fuel, lubricants and coolants according to the applicable provisions forenvironmental protection. If fuel, lubricants and coolants escape from the machine, do not operate the machine any longer andhave it repaired immediately by the Wacker Neuson contact partner.4.10 MaintenanceThe following notes must be observed: This machine may not be maintained, repaired, adjusted or cleaned while switched on. Adhere to maintenance intervals. After each maintenance or repair, the safety devices on this machine must be reattached. Observe the maintenance schedule. Non-listed work must be taken over by the service departmentof the Wacker Neuson contact partner. Immediately replace worn or damaged machine parts. Only use spare parts from Wacker Neuson. Keep the machine clean. Missing, damaged, or illegible safety warning labels should be replaced immediately. Safety stickerscontain important information for the protection of the operator. Maintenance jobs must be performed in a clean and dry vicinity (e.g. workshop).NOTICEThis machine is equipped with a certified engine (e.g. EU type approval, EPA).Adjusting the revolutions per minute (rpm) impacts the certification and the emissions. Settings forthis engine may only be carried out by a professional.For more information, contact the engine manufacturer or your Wacker Neuson contact partner.