Wahl MAX 45 Instructions Manual

Also see for KM10: CLEANING

Contents

12Description of parts (Fig. 1)A. Blade setB. Release button for blade setC. On/off switchD. Hang-up loopE. Mains cableF. Cleaning brushG. Oil for blade setH. Plug-in transformerMains Operation1. Connect to the mains power supply (Fig. 2)2. Switch on the appliance using the on/off switch (Fig. 3a) and switch off after use (Fig. 3b).The appliance has two speed settings.These can be selected via the on/off switch.Setting I = slow speedSetting II = high speedCutting with the attachment combThe appliance can also be operated with attachment combs. Attachment combs can be used to extendthe cutting length range.For best results we recommend using a #30 or #10 blade with the comb attachments.Accessories are available from your local dealer.Attaching / removing the attachment comb1. Fit the attachment comb onto the bottom edge of the blade set (Fig. 4a) and push it over the cuttingedge of the bottom blade until it locks (Fig. 4b).2. Push the attachment comb towards the cutting edge of the bottom blade (Fig. 5) and remove it fromthe blade set.Changing the blade setTo remove a blade set:1. Switch off the appliance using the on/off switch (Fig. 3).2. Press the release button (B) (Fig. 6a) towards the blade set and lift the blade set away from thehousing (Fig. 6b).3. Remove the blade set from the clip (Fig. 6c).To attach a new blade set:1. Attach the new blade set onto the clip (Fig. 8a).2. Ensure that the clip is folded out. If this is not the case, you can fold out the clip with a flatscrewdriver (Fig. 7).3. Push the blade towards the machine to snap into place.4. If the blade fails to engage, switch the appliance on (Fig. 3), then push the blade set against thehand-held appliance until it audibly clicks into place and the blade moves (Fig. 8b).Remove the attachment comb (Fig. 5) after every use and lift the blade set out of the casing (Fig. 6).Use the cleaning brush to remove any cut hairs from the housing opening and from the blade set (Fig. 9).Caution! Injuries due to incorrect handling.The blade set must not be unscrewed.The top blade must not be pushed out completely!• Push the top blade to the side (Fig. 9a) and remove cut hairs from the top and bottom blade usingthe cleaning brush.• After cleaning, return the top blade to its initial position (Fig. 9b). The top blade should be aligned inthe centre of the bottom blade. After cleaning the blade set, we recommend using hygienic spray.It keeps all blade sets hygienically clean and is effective against bacteria and viruses.• Oil the blade set with the blade set oil (Fig. 10).• We recommend that you clean and care for your blade set during and after clipping.Model: KM5 - CORDED DOG CLIPPER WM6260KM10 - CORDED DOG CLIPPER WM6261