Waldorf RN8200G Series Installation And Operation Manual

Also see for RN8200G Series: Installation and operation manual Installation and operation manual Installation and operation manual

Contents

Waldorf RN8200G Series Installation And Operation Manual Manual pdf 13 page image

11InstallationInstallation RequirementsNOTE: It is most important that this Cooktop is installed correctly and that operation is correctbefore use. Installation shall comply with local gas, health and safety requirements. This appliance shall be installed with sufficient ventilation to prevent the occurrence ofunacceptable concentrations of health harmful substances in the room, the appliance isinstalled in.Waldorf Cooktops are designed to provide years of satisfactory service, and correct installation is essentialto achieve the best performance, efficiency and trouble-free operation.This appliance must be installed in accordance with National installation codes and in addition, inaccordance with relevant National / Local codes covering gas and fire safety.AUSTRALIA: - AS5601 - Gas Installations.NEW ZEALAND: - NZS5261 - Gas Installation.UNITED KINGDOM: - Gas Safety (Installation & Use) Regulations 1998.- BS6173 - Installation of Catering Appliances.- BS5440 1 & 2 - Installation Flueing & Ventilation.IRELAND: - IS 820 - Non - Domestic Gas Installations.Installations must be carried out by qualified service persons only. Failure to installequipment to relevant codes and manufacturer’s specifications shown in this section will voidthe warranty.Components having adjustments protected (e.g. paint sealed) by the manufacturer are onlyto be adjusted by an authorised service agent. They are not to be adjusted by the installationperson.Unpacking Remove all packaging and transit protection from appliance including all protective plastic coatingfrom exterior stainless steel panels. Check equipment and parts for damage. Report any damage immediately to the carrier anddistributor. Report any deficiencies to distributor who supplied appliance. Check available gas supply is correct to that shown on Rating Plate attached to underside of R/ Hside, front Cooktop lower trim, for Bench, Cabinet Base and Leg Stand Models. For RefrigeratedBase Models, rating plate is located inside right hand front panel and can be viewed through uppergrille.Location1. Installation must allow for a sufficient flow of fresh air for the combustion air supply.2. Installation must include adequate ventilation means, to prevent dangerous build up of combustionproducts.3. Never directly connect a ventilation system to appliance flue outlet.4. Position appliance in its approximate working position.5. All air for burner combustion is supplied from underneath appliance. Legs must always be fitted andno obstructions placed on underside or around base of appliance, as obstructions will cause incorrectoperation and / or failure of appliance.NOTE: Do not obstruct or block appliance flue. Never directly connect a ventilation system toappliance flue outlet.Combustion Air Requirements:RN8200G RN8400G RN8600G RN8800GNatural Gas (G20) 12m3 /hr 24m3 /hr 36m3 /hr 48m3 /hrLPG / Propane (G31) 13m3 /hr 25m3 /hr 38m3 /hr 50m3 /hr