Waldorf RN8510GE Operation Manual

Also see for 800 SERIES: Installation and operation manual Installation and operation manual Installation and operation manual Installation and operation manual Installation and operation manual

Waldorf RN8510GE Operation Manual Manual pdf 11 page image

9Installation RequirementsNOTE:• It is most important that this appliance is installed correctly and that operation is correctbefore use. Installation shall comply with local electrical, gas, health and safetyrequirements.• This appliance shall be installed with sufficient ventilation to prevent the occurrence ofunacceptable concentrations of health harmful substances in the room, the appliance isinstalled in.Waldorf Gas Range Convection Ovens are designed to provide years of satisfactory service, and correctinstallation is essential to achieve the best performance, efficiency and trouble-free operation.This appliance must be installed in accordance with National installation codes and in addition, inaccordance with relevant National / Local codes covering gas, electrical and fire safety.Australia: - AS5601 - Gas Installations.New Zealand: - NZS5261 - Gas Installation.Australia / New Zealand: - AS / NZS3000 - Wiring Rules.United Kingdom: - Gas Safety (Installation & Use) Regulations 1998.- BS6173 - Installation of Catering Appliances.- BS5440 1 & 2 - Installation Flueing & Ventilation.- BS7671 - Requirements for Electrical Installation.Ireland: - IS 820 - Non - Domestic Gas Installations.Installations must be carried out by qualified persons only. Failure to install equipment to therelevant codes and manufacturer’s specifications shown in this section will void thewarranty.Components having adjustments protected (e.g. paint sealed) by the manufacturer are onlyallowed to be adjusted by an authorised service agent. They are not to be adjusted by theinstallation person.Unpacking• Remove all packaging and transit protection from the appliance including all protective plasticcoating from the exterior stainless steel panels.• Check equipment and parts for damage. Report any damage immediately to the carrier anddistributor.• Report any deficiencies to the distributor who supplied the appliance.• Check that the available gas and electrical supply is correct to that shown on the rating plate locatedon the front right hand corner of the bottom sill.Location1. Installation must allow for a sufficient flow of fresh air for the combustion air supply.2. Installation must include adequate ventilation means, to prevent dangerous build up of combustionproducts.3. Never directly connect a ventilation system to the appliance flue outlet.4. Position the appliance in its approximate working position.5. All air for burner combustion is supplied from underneath the appliance. The legs must always befitted and no obstructions placed on the underside or around the base of the appliance, asobstructions will cause incorrect operation and / or failure of the appliance.NOTE: Do not obstruct or block the appliances flue. Never directly connect a ventilationsystem to the appliance flue outlet.InstallationCombustion Air Requirements:RN8510GE / GEC RN8610GE / GEC RN8810GE / GECNatural Gas (G20) 29 m3 /hr 44 m3 /hr 58 m3 /hrLPG (G31) 30 m3 /hr 45 m3 /hr 60 m3 /hr