Waldorf RNL8510G Installation And Operation Manual

Also see for 800 SERIES: Operation manual Installation and operation manual Installation and operation manual Installation and operation manual Installation and operation manual

Contents

Waldorf RNL8510G Installation And Operation Manual Manual pdf 16 page image

14OperationGriddleLighting the Griddlea. Depress gas control knob and rotate anti-clockwise to ‘PILOT’ position.b. Hold gas control knob depressed, press piezo ignition button to ignite pilot burner. Repeat Items1 to 2 until pilot is lit.c. Release gas control knob approximately 10-20 seconds after lighting pilot.d. Pilot should now remain alight - if not, repeat Steps (b. to (c. above.e. To select ‘Full Flame’, depress and rotate gas control knob anti-clockwise to ‘HIGH’ position.f. To select ‘Low Flame’, depress and rotate gas control knob fully anti-clockwise to ‘Low Flame’position.g. When main burner is not required, depress and turn gas control knob clockwise back to ‘OFF’position.Turning 'OFF' the Griddle Burner / Pilota. To turn 'OFF' griddle, but keep pilot burner alight, rotate gas control knob to 'PILOT' position.Griddle burner will extinguish and pilot will remain alight.b. To turn 'OFF' 'PILOT', depress and turn gas control knob clockwise back to ‘OFF’ position. 'PILOT'burner will extinguish.Lighting the Oven Pilot BurnerThis oven is fitted with a pilot as a standard option and flamefailure protection, which is incorporated by way of athermo-electric system for the main burner. Flame failureprotection will shut off gas supply to burner in the event thatpilot burner goes out, so that un-burnt gas is not expelled.This is an important safety feature which is slowlybecoming law throughout the world.1. Open the oven door. Partially depress the thermostatcontrol knob whilst turning anti-clockwise to the ‘Pilot’position. DO NOT fully depress Control Knob whilsttrying to rotate anti-clockwise as Knob and GasValve will be damaged.2. With thermostat control knob in ‘Pilot’ position, keep knobdepressed whilst pressing piezo igniter button. (Each pressof piezo igniter button will generate a single spark).3. Hold in thermostat control knob for approx. 10-20 seconds,then release. Pilot burner should remain alight. (If pilotdoes not light, repeat Items 1 to 3 above).4. View oven pilot burner through holes in front of sole platewith oven door open.Pilot Burnerviewing holesFig 4Control Knob inPilot PositionDepress and Rotate KnobAnti-Clockwise to Pilot PositionPiezo IgniterButtonDO NOT USE aluminium foil or trays directly on cast iron sole plate(s). NEVER block or coveropenings on each side of sole plate(s).! IMPORTANT