Wallbox Pulsar Installation Manual

Also see for PULSAR: Installation guide Manual Installation guide Installation guide Quick installation guide

Contents

10ENMaximum torque for the connectors with screws is 0.9 Nm.Always use standard cables that can drive the current that has been setup in the currentselector.2. Current selectorUse the selector to select the maximum inputcurrent of the device. Positions 0, 8 and 9 arereserved for the Power Sharing Smart feature (I-5).3. Electrical connection3-A. Rear connectionStep 3-A.1: In the back of your Wallbox an area with a thinner wall can be found; use a cutter or any sharptool and make an incision for entry of the cable.Step 3-A.2: Carefully and firmly insert the power cable through the board. The board has been designedso cables from 11 to 17 mm can pass through it, which is the standard for cables that can drive up to 22 kW.Step 3-A.3: Proceed to fix the charger to the wall. Insert the screws in the marked positions, starting at the topand following a clockwise direction (I-6.1). Check that your Wallbox Pulsar is firmly fixed to the wall.Step 3-A.4: Make sure the previous steps have been completed correctly.3-B. Lower connectionStep 3-B.1: Proceed to fix the charger to the wall. Insert the screws in the marked positions, starting at the topand following a clockwise direction (I-6.1). Check that your Wallbox Pulsar is firmly fixed to the wall.Step 3-B.2: Insert the power supply cables through the cable connector (I-6.2, I-6.3).Step 3-B.3: Make sure the previous steps have been completed correctly.I-5: Current selectorConnect the neutral and earth power lines to the terminal according to the supply configuration (I-6.2, I-6.3).CURRENT (A) R 13 326 16 R10 2520 R0 3 71 4 82 65 9POSITIONIn the case that your Wallbox uses the rear input follow the steps in section 3-A. Otherwise go to section 3-B.0123456789