Waring CTS1000 User Manual

Also see for CTS1000: Instruction book Manual

Contents

Waring CTS1000 User Manual Manual pdf 5 page image

OPERATION INSTRUCTIONSCTS1000/CTS1000CNDthere are four unattached feet. each has a screw protruding fromthe top for assembly. Locate the four screw holes at each cornerof the bottom housing. Insert the screw and turn clockwise untilsnug. Repeat for remaining feet.Initial Preparation1. Place Waring ® Commercial Conveyor toaster on levelcountertop with a minimum of a 2" clearance betweenthe side and back walls.NOTE: If unit is not seated properly, the feet are adjustable forbalancing.2. Remove all parts (reflector/crumb tray and toast drawer) andclean thoroughly before first use.3. Replace all parts and plug unit into appropriate outlet(see previous page).4. Switch unit to the oN position. the red PoWeR oNindicator light will illuminate.IMPORTANT: Make sure the standby switch is in the full powerposition (to the left).5. When conveyor toaster is ready for toasting, the greenReADy indicator light will illuminate. this should takeapproximately 5 minutes.6. turn the conveyor speed control knob to set the desiredtoasting speed and shade.7. When the main power switch is turned to the oFFposition, the cooling fan and green ReADy indicator lightmay stay on up to 15 minutes for cooling.Toasting8. Place bread, bagel or muffin to be toasted on wirebread feeder. the conveyor toaster will automatically pullbread into the toasting chamber at the speed set by theconveyor speed control knob.9. When complete, toast will slide down bread chute into thetoast drawer.10. If toast is too light or too dark, adjust the speed control.turn the knob to the right for lighter toasting. turn theknob to the left for darker toasting. For best results, useday-old bread stored at room temperature.Standby Function11. During long periods of inactivity, the standby switch can beused to decrease the unit to ¼ power. the switch is foundbelow the conveyor speed control knob and should beswitched to the right to activate this feature. this is done tosave power and energy during idle periods and extend thelife of the toaster’s components. When full power is neededonce again, switch back to the left and allow 3 to 4 minutesfor unit to heat up again. the green indicator light willilluminate when unit is ready to toast.CTS1000BInitial Preparation1. Follow instructions 1 through 3 in previous section.2. turn the unit to the desired function by twisting the functionknob located at the bottom of the control panel. the redPoWeR oN indicator light will illuminate.3. When conveyor toaster is ready for toasting, the greenReADy/Hot indicator light will illuminate. this should takeapproximately 5 minutes.4. turn the conveyor speed control knob to set the desiredtoasting speed, 1 being the fastest speed and 9 being theslowest.5. turn the power control to the desired setting, 1 being thelightest setting and 9 being the darkest setting.6. the darkness of your toast/bagel will depend on how hotand how fast you select your controls.7. When selecting the bagel function, only the bottom elementswill operate.Toasting8. Place bread, bagel or muffin to be toasted on wire breadfeeder. the conveyor toaster will automatically pull breadinto the toasting chamber at the speed set by the conveyorspeed control knob.7 8