Warren FW-30 Operation And Maintenance Manual
                                         | |
Contents
| 
Warren Elevating 5th Wheel 12Method 2If the lowest down height is required, use two steel angles on each side. Position the 5th wheelframe directly on top of the tractor frame. Bolt one, angle against the side of the tractor framewith the short leg down, and the long leg facing outward. Position the second angle on-top of thefirst angle with the long leg up, and the short leg facing outward. Weld the second angle to the5th wheel frame. Bolt the two angles together in several places, and then weld the two anglestogether.Introduction to Operating ControlsAs a standard, your 5th wheel has been provided with an air shifting hydraulic pump. The controlvalve, air lines, and fittings are also included. Also standard is an air control valve. This pushbutton will prevent the driver from running the PTO while driving, and therefore, result in longerpump and PTO life.King Ping Jaw ReleaseIncluded with all 5th wheel models is an air valve for the king pin jaw release. Instructions forinstalling this valve will be found as part of the installation procedure later in this manual.Image 1 ConsolePower Take-OffPower Take Off InstallationInstall and adjust PTO according to the manufacturer’s instructions.Jaw ControlPump ValvePTO Valve |
manualsdatabase
Your AI-powered manual search engine