Wascomat W620 Classic Service Manual

Also see for W620 Classic: Service manual

30 30. Motor8ServiceManual47415466B, CAAdjust drive belt tension if values exceedthose shown in the table.Retaining screw for drive belt tensionLocking nutFig.7Fig.8783. Connect the new motor to the cable and usestraps to secure the cable.4. Connect the motor cable to the motor.5. Fit the lower rear piece and secure the drainhose connection with screws.6. Fit the upper rear piece.7. Connect the voltage supply and verify that themotor operates normally.AdjustmentsDrive belt tensionThe drive belt is pre-tensioned upon deliveryfrom the factory.The drive belt tension should be as follows:Model Force A Post tensioning B New belt C(N) (mm) (mm)W375N 35 8 6W385N 35 9 8W3105N 40 8 7W3130N 40 8 7W3180N 60 9 7W3250N 68 8 7W3330N 45 8 6To adjust drive belt tension, first undo the motorretaining screw a couple of turns, then pressdown on the motor to achieve proper tensioning.Lock the locking nut when the tension is correct.Then lock the retaining screw.Inspection of the drive belt tension is animportant part of general maintenance.Adjusting screw