Configuring the MUVPN Client200 WatchGuard Firebox X Edge9 Click Yes to restart the computer.The computer restarts and your settings are applied.Windows 2000 setupUse this section to install and configure the network componentsfor the Windows 2000 operating system. These components must beinstalled before you can use the MUVPN client on a Windows 2000computer.From the Windows desktop:1 Select Start > Settings > Network and Dial-up Connections.2 Right-click the connection you use to get Internet access andselect Properties.The connection properties window appears.3 Click the Networking tab.4 Make sure these components are installed and enabled:To enable a component, click the adjacent check box. If a component isnot installed, follow the instructions to install it.- Internet Protocol (TCP/IP)- File and Printer Sharing for Microsoft Networks- Client for Microsoft NetworksInstalling the Internet Protocol (TCP/IP) networkcomponentFrom the connection window Networking tab:1 Click Install.The Select Network Component Type window appears.2 Double-click the Protocol network component.The Select Network Protocol window appears.3 Below the Microsoft manufacturer, select the Internet Protocol(TCP/IP) network protocol and click OK.Installing the File and Printer Sharing for MicrosoftNetworksFrom the connection window Networking tab:1 Click Install.The Select Network Component Type window appears.2 Double-click the Services network component.The Select Network Service window appears.
