Waterpik Water Flosser plus WP-900 Instruction Manual

Contents

7WaterpiCleaningBefore cleaning, unplug from the electrical outlet.Clean the product when necessary by using a softcloth and mild non-abrasive cleanser.The accessory storage container and the waterreservoir are removable for easy cleaning and aretop rack dishwasher safe.NOTE: Remove reservoir valve before placingreservoir in dishwasher.Removing Hard Water DepositsAdd 2 tablespoons of white vinegar to a fullreservoir of warm water. Set pressure control dialto high, point the handle and tip into sink. Turnunit ON and run until reservoir is empty. Rinse byrepeating with a full reservoir of clean warm water.LeakageIf leaking due to a damaged hose, replacementhoses and handles can be purchased atwww.waterpik.co.uk or contact Water Pik Inc.customer service for a self service repair kit.If leakage occurs from the reservoir,ensure the valve is right side up orcontact Water Pik Inc. customerservice for a replacement valve.Tongue Cleaner TipTo use the tongue cleaner tip,set to lowest pressure setting,place tip in the center/middle ofyour tongue about half way back andstart the Water Flosser. Pull forward withlight pressure. Increase pressure as you prefer.Orthodontic TipTo use the OrthodonticTip, gently glide tipalong gumline, pausingbriefly to lightly brush area between teeth and allaround orthodontic bracket, before proceeding tothe next tooth.Plaque Seeker ® TipTo use the PlaqueSeeker ® Tip, placethe tip close tothe teeth so that the bristles are gently touchingthe teeth. Gently glide tip along gumline, pausingbriefly between teeth to gently brush and allow thewater to flow between the teeth.Using Mouthwash and Other SolutionsYour Waterpik ® Water Flosser can be used to delivermouthwash and antibacterial solutions. After usingany special solution, rinse unit to prevent clogging bypartially filling reservoir with warm water and runningunit with tip pointed into sink until unit is empty.Remove ReplaceCLEANING AND TROUBLESHOOTING YOUR WATERPIK ® WATER FLOSSER