WattAge F-86 Sabre EDF Instructions For Final Assembly

WattAge F-86 Sabre EDF Instructions For Final Assembly Manual pdf 10 page image

10 Need help or have any questions? Call us at 1-714-963-0329 or send us an E-mail to service@globalhobby.netq Kwik Bond 5 Minute Epoxyq Excel Modeling Knifeq Scissorsq 220 Grit Sandpaper w/Sanding BlockYOU'LL NEED THE FOLLOWING PARTS:q (1) Left & Right Fuselage HalvesSECTION 6: FUSELAGE ASSEMBLYq (1) Radio TrayYOU'LL NEED THE FOLLOWING TOOLS AND SUPPLIES:q Paper Towelsq Rubbing Alcoholq NHP Epoxy Mixing Sticksq NHP Epoxy Mixing CupsStep 1: Test-Fitting the Ducted Fan Assemblyq Using 220 grit sandpaper with a sanding block, lightly sand the gluing surfaces on each fuselage side smooth andstraight. If any paint is oversprayed onto the gluing surfaces, be sure to sand it away for a stronger glue joint.q Using a modeling knife, carefully cut away the foam inthe right fuselage side to extend the small premolded channelup to the cockpit area.+ The motor wires will lay in the channel, keeping themcompletely out of the intake duct.q Test-fit the ducted fan assembly into the fuselage side.The molded lip at the front of the fan shroud fits into the moldedgroove in the fuselage side and the motor wires should bepulled forward and laid in the groove as shown.+ Notice the impeller is toward the front of the fuselage.