WattAge Tangent Instructions Manual

Contents

WattAge Tangent Instructions Manual Manual pdf 32 page image

32 Need help or have any questions? Call us at 1-714-963-0329 or send us an email to service@globalhobby.netq Attach the servo horn to the Z-Bends, then attach theservo horn to the servo, making sure that it's centered.+ You will have to enlarge the holes in the servo arms usinga 1/16" drill bit so that you can attach the pushrods.q Install and tighten the servo horn retaining screw, providedwith your servo, to secure the servo horn into place.q Kwik Bond 5 Minute Epoxyq Kwik Bond Thin C/Aq Rulerq Pencilq 220 Grit Sandpaper w/Sanding BlockYOU'LL NEED THE FOLLOWING PARTS:q (2) Prebent Main Landing Gear Wiresq (2) Plastic Main Gear Wheelsq (2) Plastic Main Gear Wheel RetainersSECTION 11: MAIN LANDING GEAR INSTALLATIONq (2) Rubber Bandsq (2) Nylon Main Landing Gear MountsYOU'LL NEED THE FOLLOWING TOOLS AND SUPPLIES:q Paper Towelsq Rubbing Alcoholq NHP Epoxy Mixing Sticksq NHP Epoxy Mixing CupsIf you plan on strictly flying your Tangent EP off of grass we suggest not installing the main gear assembly. The maingear is not necessary for landing on grass and will only cause complication.Step 1: Installing the Landing Gear Wiresq Carefully push the prebent loop in each landing gear wirethrough the molded slot in the two nylon landing gear mounts.+ Make sure the prebent loop is pushed into the slot as faras possible, as shown.+ If you ever want to remove the landing gear after it has been glued to the wing, you can simply squeeze the prebentloop together and pull the wire from the nylon mount.