SmartSensor HDQUICK-REFERENCE GUIDEwww.wavetronix.com801.734.72002 Select a mounting height1 Ensure that all necessary components are availableYou will need a number of items in order to install your sensor, including but not limited to the items below:Use the table to select the mount-ing height for the sensor based onthe offset from the nearest detec-tion lane. The range of ideal offsetsis highlighted in gray. If possible,use the height contained in thesecond column (RecommendedMounting Height).In areas with a lot of truck traffic,consider a higher mounting heightto help mitigate occlusion.Note. This table is truncated. Fora complete table, refer to the HDuser guide.Offset from firstDetection Lane(ft/m)RecommendedMounting Height(ft/m)MinimumMounting Height(ft/m)MaximumMounting Height(ft/m)6 / 1.8 12 / 3.7 9 / 2.7 19* / 5.8*10 / 3 12 / 3.7 9 / 2.7 22 / 6.715 / 4.6 15 / 4.6 12 / 3.7 26 / 7.920 / 6 18 / 5.5 15 / 4.6 30 / 9.125 / 7.6 26 / 7.9 17 / 5.2 33 / 1030 / 9.1 29 / 8.8 19 / 5.8 37 / 11.235 / 10.7 30 / 9.1 20 / 6 40 / 12.240 / 12.2 33 / 10 22 / 6.7 43 / 13.145 / 13.7 36 / 11 23 / 7 40 / 1450 / 15.2 39 / 11.9 25 / 7.6 50 / 15.2*Reduction in number of reported speeds˽ Mount bracket and Band-It clamping system˽ Sensor cable and homerun cable˽ Click equipment and pole-mount box˽ Laptop with SmartSensor Manager HD, down-loaded from wavetronix.com˽ Bucket truck1 Attach the mount bracket to the pole using the straps.2 Tighten the strap screws partway. The sensor alignment will need tobe fine-tuned later, so keep the straps slightly loose.3 Attach the sensor to the bracket; the connector at the bottom of theunit should point towards the ground.4 Place the lock washers onto the bolts, thread on the nuts and tighten.3 Attach the sensor and mount bracket to the pole