Wayne 321304-001 Operating Instructions And Parts Manual

Contents

specifications

Wayne 321304-001 Operating Instructions And Parts Manual Manual pdf 1 page image

Self-Priming PortableUtility PumpPlease read and save these instructions. Read carefully before attempting to assemble, install, operate or maintain the product described.Protect yourself and others by observing all safety information. Failure to comply with instructions could result in personal injury and/or prop-erty damage! Retain instructions for future reference.DescriptionThis self-priming portable utility pumpis designed to be used as a transferpump for such applications as emptyingwater heaters, swimming pools, live-stock tanks, boats, etc. Pump can alsobe used for an intermittent pressureboost for applications such as washingcars, cleaning driveways, etc. The motoris air cooled; it is not designed to oper-ate under water.NOTE: This pump is not intended forpermanent installation or long, extend-ed periods of continuous operation.Safety GuidelinesThis manual contains information that isvery important to know and under-stand. This information is provided forSAFETY and to PREVENT EQUIPMENTPROBLEMS. To help recognize this infor-mation, observe the following symbols.Danger indicatesan imminently haz-ardous situation which, if not avoided,will result in death or serious injury.Warning indicatesa potentially haz-ardous situation which, if not avoided,could result in death or serious injury.Caution indicates apotentially haz-ardous situation which, if not avoided,may result in minor or moderate injury.Operating Instructions and Parts Manual Cast Iron Utility SeriesNotice indicatesimportant informa-tion, that if not followed, may causedamage to equipment.General SafetyInformationDo not submergemotor or allowmotor to be exposed to water. Personalinjury and/or death could result.Do not use to pump flam-mable or explosive fluidssuch as gasoline, fuel oil,kerosene, etc. Do not usein a flammable and/or explosive atmos-phere. Pump should only be used topump clear water. Personal injuryand/or death could result.Risk of electricalshock. All wiringmust be performed by a qualified elec-trician.Do not walk on wetareas until all power isturned off. Failure to fol-low this warning couldresult in fatal electrical shock.1. Read all instructions beforeoperation.2. Disconnect power and release allpressure within the system beforeservicing any component.321304-001 1/053. Drain all liquids from system beforeservicing.Secure the dis-charge line beforestarting the pump. An unsecured dis-charge line may whip. Personal injuryand/or property damage could result.4. Periodically inspect pump and sys-tem components, checking forweak and/or worn hoses. Insure allconnections are secure.5. Provide a means of pressure reliefin the case of an obstructed dis-charge line.6. Protect electrical cord from sharpobjects, hot surfaces, oil and chemi-cals. Avoid kinking the cord andreplace damaged cords immediately.InstallationAlways disconnect powersource before attemptingto install, service, ormaintain the pump. Neverhandle a pump with wet hands orwhen standing on wet or damp sur-face or in water. Fatal electrical shockcould occur.1. A ground fault circuit interrupter(GFCI) is required.Risk of electrical shock!This pump is suppliedwith a grounding conducSpecificationsMotor . . . . . . . . . . . . . .Single Phase - 115V, 60 Hz, 8,000 RPM . . . .Horsepower . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1/2 HPMotor . . . . . . . . .Series Wound (brush type) AC/DC Operation . . . .Inlet/Outlet Openings . . . . . . . . . . . . . . . . . . . . . . .3/4” NPTImpeller . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .SAN . . . .Pump Housing . . . . . . . . . . . . . . . . . . . . . . . . . . . . .Cast ironMotor Housing . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .Cast iron . . . .Motor Shaft . . . . . . . . . . . . . . . . . . . . . . . .Cold rolled steelShaft and Volute Seal . . . . . . . . . . . . . . . . . . . . . . . . . . .Buna-N . . . .Motor Bearings . . . . . . . . . . . . . . . .Permanently lubricatedMaximum Fluid Temperature . . . . . . . . . . . . . . . . . . . . . .120˚F . . . .© 2005 Wayne Water Systems For parts, product & service informationvisit www.waynepumps.comREMINDER: Keep your dated proof of purchase for warranty purposes! Attach it to this manual or file it for safekeeping.