Wayne-Dalton 8000 Quick Start Manual

Also see for 8000 Series: Installation instructions and owner's manual Installation instructions and owner's manual Installation instructions and owner's manua Installation instructions and owner's manual Installation instructions and owner's manual

Contents

limited warranty

Wayne-Dalton 8000 Quick Start Manual Manual pdf 9 page image

to lubricate.CHECK FOR PRESENCE OF SAFETY LABELS:WARNINGWARNINGLift handles/gripping points are requiredon this door, located as spelled out in theinstallation instructions, even if the dooris motor operated.Failure to install and use these lift handles/gripping points on this door can result inserious injury to fingers and/or hands, ifplaced in the opening between sections,when the door is operated manually.The adjacent bottom corner bracket andall cable retention features includingmilford pins, cotter pins, & clevis pins areunder HIGH SPRING TENSION.Adjustments and repairs must only bemade by a trained door systemstechnician, using proper tools andinstructions.DO NOT REMOVE, COVER OR PAINT OVERTHIS LABEL. PRODUCT USER SHOULDINSPECT THIS LABEL PERIODICALLY FORLEGIBILITY AND SHOULD ORDER AREPLACEMENT FROM THE DOORMANUFACTURER AS NEEDED.325304 REV3 06/26/12© Copyright 2012,Overhead Door CorporationWARNINGWARNINGLift handles/gripping points are requiredon this door, located as spelled out in theinstallation instructions, even if the dooris motor operated.Failure to install and use these lift handles/gripping points on this door can result inserious injury to fingers and/or hands, ifplaced in the opening between sections,when the door is operated manually.The adjacent bottom corner bracket andall cable retention features includingmilford pins, cotter pins, & clevis pins areunder HIGH SPRING TENSION.Adjustments and repairs must only bemade by a trained door systemstechnician, using proper tools andinstructions.DO NOT REMOVE, COVER OR PAINT OVERTHIS LABEL. PRODUCT USER SHOULDINSPECT THIS LABEL PERIODICALLY FORLEGIBILITY AND SHOULD ORDER AREPLACEMENT FROM THE DOORMANUFACTURER AS NEEDED.325304 REV3 06/26/12© Copyright 2012,Overhead Door CorporationSpring TurnsDoor Height Spring Turns(6’ - 0”) 14(6’ - 3”) 14 - 1/2(6’ - 5”) 15(6’ - 6”) 15(6’ - 8”) 15 - 1/2(6’ - 9”) 15 - 1/2(7’ - 0”) 16(7’ - 3”) 16 - 1/2(7’ - 6”) 17(7’ - 9”) 17 - 1/2(8’ - 0”) 18Number of Installed Spring Turns300547 REV2 01/15/2010Copyright 2010 Wayne Dalton, aDivision of Overhead Door Corp.HIGH SPRING TENSION CAN CAUSESERIOUS INJURY OR DEATH.DO NOT adjust, repair or remove springs or parts towhich springs are connected, such as steel brack-ets, cables, wood blocks, fasteners or other parts ofthe counterbalance system.Adjustments or repairs must ONLY be made by atrained door systems technician using proper toolsand instructions.DO NOT remove, cover or paint over this tag. Prod-uct user should inspect this tag periodically forlegibility and should order a replacement tag fromthe door manufacturer, as needed.©Copyright 2010 Overhead Door Corporation 102081 REV2 06/24/2010SAFETY INSTRUCTIONS1. Operate door ONLY when it is properlyadjusted and free of obstructions.2. If a door becomes hard to operate,inoperative or is damaged, immediatelyhave necessary adjustments and/or repairsmade by a trained door system technicianusing proper tools and instructions.3. DO NOT stand or walk under a moving door,or permit anybody to stand or walk underan electrically operated door.4. DO NOT place fingers or hands into opensection joints when closing a door. Use lifthandles/gripping points when operatingdoor manually.5. DO NOT permit children to operate garagedoor or door controls.6. Due to constant extreme spring tension,DO NOT attempt any adjustment, repair oralteration to any part of the door,especially to springs, spring brackets,bottom corner brackets, red coloredfasteners, cables or supports. To avoidpossible severe or fatal injury, have anysuch work performed by a trained doorsystem technician using proper tools andinstructions.7. On electrically operated doors, pull downropes must be removed and locks must beremoved or made inoperative in the open(unlocked) position.8. Top section of door may need to bereinforced when attaching an electricopener. Check door and/or openermanufacturer’s instructions.9. VISUALLY inspect door and hardwaremonthly for worn and/or broken parts.Check to ensure door operates freely.10. Test electric opener’s safety featuresmonthly, following opener manufacturer’sinstructions.11. NEVER hang tools, bicycles, hoses, clothingor anything else from horizontal tracks.Track systems are not intended or designedto support such extra weight.Place label at a readable height on door. DO NOTremove, cover or paint over this label. Productuser should inspect this label periodically forlegibility and should order a replacement labelfrom the door manufacturer as needed.324100 REV7 09/16/2013Quality garage doors since 1954Wayne Dalton2501 S. State Hwy 121 Bus., Suite 200Lewisville, TX 75067For service, call (800) 827-3667www.Wayne-Dalton.comCopyright 2013 Wayne Dalton, aDivision of Overhead Door Corp.Residential warning label, The warning label willeither be on the right or the left end stile.Bottom corner bracket warning labelsTorsion spring tag(s)(one per spring)TorqueMaster® Plus tag(s)(one per spring)WARRANTYLimited WarrantyModels 8000, 8100, 8200Wayne Dalton, a division of Overhead Door Corporation ("Seller") war-rants to the original purchaser of the Models 8000, 8100, 8200 (“Product”),subject to all of the terms and conditions hereof, that the Product and allcomponents thereof will be free from defects in materials and workmanship forthe following period(s) of time, measured from the date of installation:TEN (10) YEARS from the date of installation against:• The Product becoming inoperable due to rust-through of the steel skinfrom the core of the Product section, due to cracking, splitting, or otherdeterioration of the steel skin, or due to structural failure caused byseparation or degradation of the foam insulation.• Peeling of the original paint as a result of a defect in the original paint orin the application of the original paint coating.TEN (10) YEARS on Product hardware and tracks (except springs).ONE (1) YEAR on all other component and parts.Seller’s obligation under this warranty is specifically limited to repairingor replacing, at its option, any part which is determined by Seller to be defec-tive during the applicable warranty period. Any labor charges are excluded andwill be the responsibility of the purchaser.This warranty gives you specific legal rights, and you may also haveother rights which vary from state to state. This warranty is made to the origi-nal purchaser of the Product only, and is not transferable or assignable. Thiswarranty applies only to Product installed in a residential or other non-com-mercial application. It does not cover any Product installed in commercial orindustrial building applications. This warranty does not apply to any unauthor-ized alteration or repair of the Product, or to any Product or component whichhas been damaged or deteriorated due to misuse, neglect, accident, failureto provide necessary maintenance, normal wear and tear, acts of God, or anyother cause beyond the reasonable control of Seller or as a result of havingbeen exposed to toxic or abrasive environments, including blowing sand, saltwater, salt spray and toxic chemicals and fumes.ALL EXPRESS AND IMPLIED WARRANTIES FOR THE PRODUCT, INCLUD-ING BUT NOT LIMITED TO ANY IMPLIED WARRANTIES OF MERCHANTABILITYAND FITNESS FOR A PARTICULAR PURPOSE, ARE LIMITED IN TIME TO THE AP-PLICABLE WARRANTY PERIOD REFLECTED ABOVE. NO WARRANTIES, WHETHEREXPRESS OR IMPLIED, WILL APPLY AFTER THE LIMITED WARRANTY PERIODHAS EXPIRED. Some states do not allow limitations on how long an impliedwarranty lasts, so the above limitation may not apply to you.IN NO EVENT SHALL SELLER BE RESPONSIBLE FOR, OR LIABLE TOANYONE FOR, SPECIAL, INDIRECT, COLLATERAL, PUNITIVE, INCIDENTAL ORCONSEQUENTIAL DAMAGES, even if Seller has been advised of the possibilityof such damages. Such excluded damages include, but are not limited to, lossof use, cost of any substitute product, or other similar indirect financial loss.Some states do not allow the exclusion or limitation of incidental or conse-quential damages, so the above limitation or exclusion may not apply to you.Claims under this warranty must be made promptly after discovery,within the applicable warranty period, and in writing to the authorized distribu-tor or installer whose name and address appear below. The purchaser mustallow Seller a reasonable opportunity to inspect any Product claimed to bedefective prior to removal or any alteration of its condition. Proof of the pur-chase and/or installation date, and identification as the original purchaser, maybe required. There are no established informal dispute resolution procedures ofthe type described in the Magnuson-Moss Warranty Act.• SELLER: _______________________________________________________________________• SELLER’S ADDRESS: ______________________________________________________________________________________________________________________________________________9

/ 10

Related manuals for Wayne-Dalton 8000 Series