Wayne-Dalton 8000 Series Installation Instructions And Owner's Manual

Also see for 8000 Series: Installation instructions and owner's manual Installation instructions and owner's manua Installation instructions and owner's manual Quick start guide Installation instructions and owner's manual

Contents

Wayne-Dalton 8000 Series Installation Instructions And Owner's Manual Manual pdf 25 page image

25Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to yourlocal yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.comTools Needed:INSTAllATIONIT IS RECOMMENDED ThATLEAThER GLOVES BE WORN WhILEWINDING ThE TORquEMASTER®PLuS SPRINGS. fAILuRE TO WEARGLOVES MAy CAuSE INjuRy TOhANDS.Double check to ensure thecounterbalance cable is aligned in the firstgroove of the cable drum as shown in Step24.PRIOR TO WINDING OR MAkINGADjuSTMENTS TO ThE SPRINGS,ENSuRE yOu’RE WINDING IN ThEPROPER DIRECTION AS STATED INThE INSTALLATION INSTRuCTIONS.OThERWISE, ThE SPRING fITTINGSMAy RELEASE fROM SPRINGIf NOT WOuND IN ThE PROPERDIRECTION AND COuLD RESuLT INSEVERE OR fATAL INjuRy.Starting with the right hand side, place amark on winding shaft (or socket) and endbracket. Turn the pawl knob on the endbracket to the upper position.IMPORTANT: using a ratchet with a 5/8”(16 mm) socket (NOTE: A 3” (76 mm)extension is recommended for addedclearance from the horizontal angle), windthe spring by rotating the winding shaftcounter clockwise, while watching themark on the winding shaft.IMPORTANT: PAWL kNOB MuST BEIN uPPER POSITION TO ADD/REMOVEREquIRED NuMBER Of SPRING TuRNS.After 2-3 turns, remove the ratchet andadjust the cable tension on the left side.Ensure the cable is in the first groove ofthe cable drums, as shown in Step 24.NOTE: Single spring applications requireno spring winding of the left hand side butneed cable tension adjustments.IMPORTANT: COuNTERBALANCE CABLETENSION MuST BE EquAL ON BOTh SIDESPRIOR TO fuLLy WINDING SPRINGS.SEE ThE SPRINg TURN ChART FOR ThEREqUIRED NUMbER OF TURNS:For single spring applications:Return to the right hand and continuewinding the spring to the required numberof turns for your door. Place pawl knob inlower position.For double spring applications:Place a mark on the winding shaft and endbracket. Place the ratchet with 5/8” socketwinding SpringsRatchet Wrench5/8” Socket3” ExtensionGlovesRECOMMENDED SPRINg TURNSDoor height Spring Turns Door height Spring Turns6’-0” 14 7’-0” 166’-3” 14-1/2 7’-3” 16-1/26’-5” 15 7’-6” 176’-6” 15 7’-9” 17-1/26’-8” 15-1/2 8’-0” 186’-9” 15-1/2END BRACkETRATChET3”EXTENSION5/8” SOCkETMARkSwARNINg25PAWL kNOB IN uPPERPOSITIONEND BRACkETwARNINg