Wayne-Dalton 9100 Installation Instruction And Owenrs Manual

Also see for 9100: Quick start owner's manual Installation instructions Installation instructions and owner's manual Installation instructions and owner's manual Installation instructions and owner's manual

Contents

Wayne-Dalton 9100 Installation Instruction And Owenrs Manual Manual pdf 4 page image

(4) 1/4”-20 x 5/8”Carriage bolts (as required)1/4”-20 x 9/16”Track bolts (as required)(2) 3/8”- 16 Hex nuts(as required) 1/4”- 20 Flangedhex nuts (as required)1/4”-14 x 5/8” Self tappingscrews (as required)(2) 3/8”-16 x 3/4”Truss head bolts3/8” - 16 x 1-1/2” Hex head bolts(as required)5/16” x 2-1/2” Hex head lag screws(RED HEAD) (as required)5/16” x 1-5/8” Hex head lag screws(as required)5/16” x 1-5/8” Hex head lag screws(RED HEAD) (as required)Door Section IdentificationEnd and center hinges are always pre-attached at the top of each section (except top sec-tion).The BOTTOM SECTION can be identified by the factory attached bottom weather seal, thefactory attached bottom corner brackets and by the bottom corner bracket warning labels oneach end stile.The LOCK SECTION can be identified having no labels attached to the section.The INTERMEDIATE SECTION I can be identified by the warning label attached to either theright or left hand end stile.The INTERMEDIATE SECTION II can be identified having no labels attached to the section.The INTERMEDIATE SECTION III can be identified having no labels attached to the section.The INTERMEDIATE SECTION IV can be identified having no labels attached to the section.The TOP SECTION can be identified with no pre-installed graduated end or center hinges.Section side view illustrationBottom cornerbracketBottomweather sealEndhingeBottomweather sealIntermediate I sectionLock sectionBottom corner bracket warning labelsBottom sectionWarning labelsTop sectionEndhingeEndhingeTools RequiredPower drill Socket driver: 7/16” LevelDrill bits: 1/8”, 3/16”,9/32”, 7/16”, 1/2”Ratchet wrench Tape measure Pliers / Wire cutters Flat tip screwdriverPhillips head screwdriver Wrenches: 3/8”, 7/16”,1/2”, 9/16”, 5/8”3” Ratchetextension Sockets: 7/16”,1/2”, 9/16”, 5/8”Vise clamps Hammer Step ladder PencilLeather glovesLocking pliersSafety glasses Approved winding barsSaw horses4