White Rodgers SST1400 Owner's Manual

Also see for Comfort Plus SST1000: Owner's manual Owner's manual Owner's manual

Contents

7VerticalSectionWood BlockTape AllJointsFigure 16HotNeutralGroundingConductorFront ViewFigure 17FloorConduitDuctElectronicAir CleanerFigure 18Cabinet Pre-Filters HandleContactButtonContactButtonCollecting CellsPower PackFigure 197. With the cabinet installed, the air cleaner can now bewired to electrical input source.WARNING!Installation of this unit must comply with localInstallation of this unit must comply with localInstallation of this unit must comply with localInstallation of this unit must comply with localInstallation of this unit must comply with localelectric codes or other applicable codes.electric codes or other applicable codes.electric codes or other applicable codes.electric codes or other applicable codes.electric codes or other applicable codes.Review and understand local codes prior to in-Review and understand local codes prior to in-Review and understand local codes prior to in-Review and understand local codes prior to in-Review and understand local codes prior to in-stallation.stallation.stallation.stallation.stallation.Failure to do so could result in serious personalFailure to do so could result in serious personalFailure to do so could result in serious personalFailure to do so could result in serious personalFailure to do so could result in serious personalinjury or death.injury or death.injury or death.injury or death.injury or death.8. This air cleaner unit has no air flow monitor installed,it does require electrical wiring through the furnacecontrols. Connect wiring to the furnace control termi-nals. (EAC-H) for power, (EAC-N) for neutral, andconnect metal frame of EAC to ground. If air flowmonitor is required for operation, order F859-0381 AirFlow kit. Install kit and connect a 120 VAC 60 Hz inputcircuit. A 20 amp circuit is more than adequate.9. Remove junction box cover and install the requiredbushing into the 3/4 in. Knock out. With the supplyvoltage turned off, route three (3) wires into junctionbox for connections. (See Fig. 17.)Insure all wires are clamped, wire connectors prop-erly installed and grommets used to prevent wireabrasion.WIRING INSTRUCTIONSWIRING INSTRUCTIONSWIRING INSTRUCTIONSWIRING INSTRUCTIONSWIRING INSTRUCTIONS10. With the cabinet Installed, reinstall pre-filter(s) andcollecting cell(s) (Figure 19).NOTE: The contact button and handles on the cellmust be facing you and ionizing wires must be on theair intake side.11. Install the power pack as follows:Engage the lip on lower inside edge of power pack inthe flange on cabinet and carefully close the powerpack, making sure that the electrical connector prongson the power pack enter the slots in the socket oncabinet. When the power pack is fully in place, en-gage the latch and snap it closed.