White Rodgers SST1600 Owner's Manual

Also see for Comfort Plus SST1000: Owner's manual Owner's manual Owner's manual

Contents

WIRING INSTRUCTIONS7. With the cabinet installed, the air cleaner can now bewired to electrical input source.Installation of this unit must comply with localelectric codes or other applicable codes.Review and understand local codes prior to instal-lation.Failure to do so could result in serious personalinjury or death.10. If this unit has an electrical cord, the cord has agrounding type plug with a third (grounding) pin. Thisplug will fit only into a grounding type power outlet. Ifthe proper type of outlet is not available, contactqualified personnel to install a proper outlet. Do notalter the plug in any way.To reuce the risk of electric shock, The power cordmust be connected to an appropriate outlet. Do notalter the plug in any way.8. An air cleaner unit with no air flow monitor requireselectrical wiring through the furnace controls. Con-nect wiring to the furnace control terminals (EAC-H)for power, (EAC-N) for neutral and connect metalframe of EAC to ground.If the air cleaner unit has an airflow monitor, it must beconnected to 120 VAC 60 Hz. A 20 amp circuit is morethan adequate. If an airflow monitor is not installed butis required for operation, order Air Flow Kit F859-0381. If a power cord is required, order F97-0019.9. Remove junction box cover and install the requiredbushing into the 3/4 in. Knock out. With the supplyvoltage turned off, route three (3) wires into junctionbox for connections. (See Fig. 17.)Insure all wires are clamped, wire connectors prop-erly installed and grommets used to prevent wireabrasion.VerticalSection\Wood Block7 Tape AllJointsHotNeutralGroundingConductorFigure 16r-==h1Front ViewFigure 1711. With the cabinet Installed, reinstall pre-filter(s) andcollecting cell(s) (Figure 18).NOTE: The contact button and handles on the cellmust be facing you and ionizing wires must be on theair intake side.12. Install the power pack as follows:Engage the lip on lower inside edge of power pack inthe flange on cabinet and carefully close the powerpack, making sure that the electrical connector prongson the power pack enter the slots in the socket oncabinet. When the power pack isfully in place, engagethe latch and snap it closed.Pre-FiltersCabinet HandleContactButtonCollectingCellsFigure 18ContactButton Power PackFemale PlugMale I_iPlug __Side Edge ofPower PackPower Pac_ _zPress to Close After_ [_ LatchLatch is Engaged / j_._D ToEngage_- Cabinet/Engage Lip on Lower Inside Edgeof Power Pack in Flange.Figure 19 Installing Power Pack