Wood Stone BISTRO Series Installation And Operation Manual

Also see for BISTRO 4343: Installation and operation manual Installation and operation manual Installation and operation manual Installation and operation manual Installation and operation manual

Contents

Dual Burner Bistro LineInstallation and Operation ManualPG 18 OF 32M0028�09 SEPTEMBER 2017An ongoing program of product improvement mayrequire us to change specifications without notice.WOOD STONE CORPORATION1801 W. Bakerview Rd.Bellingham, WA 98226 USATOLL FREE 800.988.8103TEL 360.650.1111FAX 360.650.1166E-MAIL info@woodstone-corp.comwoodstone-corp.comASSEMBLYFollow these instructions only if the oven was shipped disassembled, or disassembled to move through a narrow door orpassageway.The oven must be installed on a flat level surface� The weight of the oven is carried by the full perimeter of the oven stand� If it isnecessary to shim the oven for leveling purposes, it is critical that the shim material be metal, and that the shims are installed in sucha way that the full perimeter of the stand is solidly supported� Any gaps created by shimming between the oven and the floor must besealed for proper ventilation� Failure to solidly support the full perimeter of the oven stand can result in costly damage to the oven andwill void the warranty�The floor design and construction must be adequate to handle the weight of the oven� Please see woodstone-corp�com/installation_footprints�htm for floor loading information�2. Use the 3/8" x 1" carriage bolts to assemble thestand� Be sure to use the washers provided and totighten nuts and bolts securely�1. Lay out pieces�Carriage Bolts3/8 x 1" (4x)3. Using a forklift or other suitable lifting device, carefully lower thebody of the oven on to the stand so that the bolt holes line up�While supporting the oven with the lift, install the 3/8-inch x 1-inchcarriage bolts� Use the washers provided and tighten all nutssecurely� Be sure to use the forklift pockets when lifting the body ofthe oven�NOTE: Oven ships with temporary 'X' braces across the front andback� Leave the 'X' bracing in place until the rear panel is installed�4. After the oven body is bolted to the stand, the oven can be moved into place with a pallet jack usingthe LOWER forklift pockets� If the oven is to be installed against a wall, leave access to the back ofthe oven until the assembly is completed� See CAUTIONS on next page�