Wood Stone TANDOOR 31 Installation And Operation Manual

Also see for BARREL TANDOOR: Installation and operation manual Installation and operation manual

Contents

PG 9 OF 16M0053�05 APRIL 2017Tandoor Installationand Operation ManualLOWER FLASHING INSTALL (BARREL)DO NOT LOWER STRIP FLASHING UNTIL TANDOOR IS LOCATED IN ITS FINAL INSTALLED POSITIONLeveling the TandoorPosition Tandoor in its final installed position�With the Flashing still in the UP position, levelthe Tandoor using the four adjustable feet�Plumbing the TandoorIf the gas connection is made below theTandoor, plumb before lowering the flange�If the gas connection is not from below theTandoor, it will be necessary to notch the flashing�This should be done after the flashingis lowered�Lowering the FlashingThe unit ships with the Strip Flashing secured intoits “UP” position with a screw at each leg�Screw holding upflashingRemove the screw from all 4 legs and lower theflashing evenly around the Tandoor, flat to the floor�Center punch and pre-drill each Leg using theexisting hole in the flashing as a guide�Secure the flashing at each leg using the screwpreviously removed�Remove the protective black Edge Cover�Center punch andpre-drill using theexisting hole as a guide,then fasten with screwProtective black Edge Cover• • • •Ü• • • •Ü• • • •Ü