Wood Stone WS-FD-9690 Series Installation And Operation Manual

Also see for WS-FD-11275 Series: Installation and operation manual

Contents

9690, 11275 & 11290 Fire Deck Coal-FiredOven Installation and Operation Manualinfo@woodstone-corp�com or visit woodstone-corp.comwood stone corporation1801 w. bakerview rd.bellingham, wa 98226 usatf. 800.988.8103t. 360.650.1111f. 360.650.1166Position a scissor jack under the ovenframe near the caster to be removed�Use the jack to raise the caster so that itclears the floor slightly (1/4" should besufficient)� Remove the nuts and boltsretaining the caster to the oven frame�Rotate the caster in the direction of thefork legs to remove from oven, thenlower the jack and proceed to the nextcaster and repeat procedure�TO MAINTAIN THE OVEN WARRANTY, SHIPPING CASTERS MUST BE REMOVED WHEN THE OVEN IS INSTALLED.The oven should be installed on a flat level surface� The weight of the oven is carried by the full perimeter of the oven stand� If itis necessary to shim the oven for leveling purposes, it is critical that the shim material be metal, and that the shims are installedin such a way that the full perimeter of the stand is solidly supported� Any gaps created by shimming between the oven and thefloor must be sealed to prevent airflow issues beneath the oven� Failure to solidly support the full perimeter of the ovenstand can result in costly damage to the oven and will void the warranty.The floor design and construction must be adequate to handle the weight of the oven�Please see woodstone-corp.com/resources/downloads/loads-footprints for floor loading information�IMPORTANT: DO NOT JACK THE FRAME ANY HIGHER THAN THE MINIMUM NECESSARY TO REMOVE THE CASTER.CASTER REMOVAL9An ongoing program of product improvement may require us to changespecifications without notice. FD-(9690, 11275, 11290)-CL,Revised March 2015. Doc no: M0045.02