X10 GB10A Operating Instructions Manual

Installing the GB10A Sensor• Peel off the paper from the double sided tape on theback and attach the Sensor to the inside of a windowthat you want to protect.• Slide the battery compartment off and install twoAAA alkaline batteries, observing polarity.• Set the switch to 2 to make the unit more sensitive tovibration, or 1 for less sensitive (helps prevent falsealarms).Glass Break Sensor, Model GB10A Set Up and Operating InstructionsX10.com, Inc., 3824 North 5th St., Suite C, North Las Vegas, NV 89032sales@x10.com http://www.x10.com GB10A-11/03Replacing batteriesOpen the battery compartment and replace the batterieswith two AAA alkaline batteries. After replacing thebatteries, the following steps are necessary to determinethat the Console still recognizes the GB10A.• Place the Console’s slide switch to RUN2.• Press TEST on the GB10A. If the Console chimes, itrecognizes the GB10A and no further action is necessary.If the Console did not chime:Place the Console’s slide switch to INSTALL. Press TESTon the GB10A. The Console beeps and logs in the GB10Ato the next available zone. To make sure the Console logsthe GB10A back into the same zone it was allocated tobefore you changed the batteries, wait 4 hours afterremoving the old batteries before reinstalling (until the zoneindicator on the Console starts flashing).X10 Wireless Technology, Inc. Limited One YearWarrantyX10.com, a division of X10 Wireless Technology, Inc.(X10) warrants X10 products to be free from defectivematerial and workmanship for a period of one (1) year fromthe original date of purchase at retail. X10 agrees to repairor replace, at its sole discretion, a defective X10 product ifreturned to X10 within the warranty period and with proofof purchase. If service is required under this warranty:Call 1-800-442-5065, visit www.x10.com, or e-mailsupport@x10.com.For help or more information on setup, please visit:http://www.x10.com/supportF.C.C. CAUTION - THIS DEVICE COMPLIES WITHPART 15 OF THE FCC RULES. OPERATION ISSUBJECT TO THE FOLLOWING TWOCONDITIONS: (1) THIS DEVICE MAY NOT CAUSEHARMFUL INTERFERENCE, AND (2) THIS DEVICEMUST ACCEPT ANY INTERFERENCE RECEIVED,INCLUDING INTERFERENCE THAT MAY CAUSEUNDESIRED OPERATION. NOTE: NO CHANGESOR MODIFICATIONS MAY BE MADE TO THEUNITS. ANY CHANGES MADE TO THE UNITSWILL VOID THE USER'S AUTHORITY TO OPERATETHE EQUIPMENT.Registering the GB10A Sensor with the SecurityConsole• Set the slide switch on the Security Console toINSTALL.• Press the TEST button on the GB10A Sensor. Theconsole beeps once to confirm and the next availablezone LED lights.• Return the console slide switch to the RUN1 orRUN2 position.Testing the GB10A Sensor• Set the slide switch on the Security Console to RUN2.• Press TEST on the GB10A. The console beeps toacknowledge and the zone LED lights.*Note: you can install a total of 16 zones in the Console.This can be a combination of Door/Window Sensors,Motion Detectors, and Glass Break Sensors. See yourSecurity System Owner’s Manual for more information.OperationThe GB10A is sensitive to vibration. When the securitysystem is armed, the vibration caused by breaking glasswill set off the alarm. You can test this by tapping on thewindow that the GB10A is attached to.GlassBreakSensorGlass BreakSensitivity1 = Low,2 = High.

/ 1

Related manuals for X10 GB10A