Xante PlateMaker 3 Manual 

Also see for PlateMaker 3: Supplementary guide

Xante PlateMaker 3 Manual  Manual pdf 238 page image

9-8 Maintenance and Specificationsbb ________________________4. Clean toner from the transfer roller with a soft bristle brush.5. Vacuum the area using a soft brush attachment or blow it withcompressed air.Warning! Wear protective safety glasses when using compressedair.Caution: Do not pull out wires while performing this step.6. Lower the roller back into place with the gear end to the left.Make sure the lever protruding below the transfer roller fitsinside the small opening on the door.7. Push the roller into its holding clips. The roller assemblyshould spring back freely when pressed.Toner and Manual Feed Area CleaningClean the toner and manual feed area after removing a paper jam orreplacing the toner cartridge.1. Turn off the printer and disconnect it from the power source;then remove the paper jam or the toner cartridge.Caution: The fuser becomes very hot during operation.Always allow the fuser to cool completely beforeopening the fuser cover. If a paper jam occurs inthe fuser area, turn off the printer and wait at least30 minutes before attempting to clear the jam.