Users safety summaryTerms in CAUTION Conditions that can result in damage to the product.manual: WARNING Conditions that can result in personal injuryor loss of life.Power source: For 110 VAC printers, Do not apply more than 140 volts RMSbetween the supply conductors or between either supply conductor and ground.Use only the specified power cord and connector. For 220 VAC printers, do notapply more than 260 volts RMS between the supply conductors or between eithersupply conductor and ground. Use only the specified power cord and connector.Refer to a qualified service technician for changes to the cord or connector.Operation of product: Avoid electric shock by contacting a qualified servicetechnician to replace fuses inside the product. Do not operate without the coversand panels properly installed. Do not operate in an atmosphere of explosivegases.Safety instructions: Read all installation instructions carefully before you plug theproduct into a power source.Terms on CAUTION A personal injury hazard exists that may not beproduct: apparent. For example, a panel may cover the hazardous area.Also applies to a hazard to property including the product itself.DANGER A personal injury hazard exists in the area whereyou see the sign.Care of product: Disconnect the power plug by pulling the plug, not the cord.Disconnect the power plug if the power cord or plug is frayed or otherwisedamaged, if you spill anything into the case, if product is exposed to any excessmoisture, if product is dropped or damaged, if you suspect that the product needsservicing or repair, and whenever you clean the product.Ground the product: Plug the three-wire power cord (with grounding prong) intogrounded AC outlets only. If necessary, contact a licensed electrician to install aproperly grounded outlet.Lifting the printer: To avoid injury or damage to the printer, use three people tolift the printer.
