Xerox 3400N - Phaser B/W Laser Printer Quick Installation Manual

Also see for 3400N - Phaser B/W Laser Printer: Brochure Network guide Service guide

Contents

Xerox 3400N - Phaser B/W Laser Printer Quick Installation Manual Manual pdf 6 page image

2 Phaser 3400 Personal Laser PrinterEnglishConnecting the Printer to the NetworkThe Phaser 3400 personal laser printer is designed to be connected tothe network with 10BaseT or 100BaseT Category 5 (Cat-5) cables. Formore information, please consult your local retailer.The following illustration shows a typical installation.1. If the printer is on, turn it off.2. Connect one end of an Ethernet cable to the Ethernet port on theprinter.3. Connect the other end of the cable to the hub. (Do not connect thecable to a port on the hub labeled Uplink.)4. Turn on the printer.5. Refer to the software setup instructions for your environment.The Ethernet hub shows the status of devices through indicator lights.There are also two green indicator lights on the back of thePhaser 3400 printer, next to the network cable. The top indicator lightshould always be on when the printer is on; it indicates a liveconnection to the network. The lower indicator light should beblinking; it indicates that the network card is active.1710-99