Xerox 4215/MRP Reference

Also see for 4215/MRP: Operation guide Quick start Installation planning guide Operator's guide

Contents

HP LASERJET EMULATION MODEImage areaFor compatibility with Hewlett-Packard printers, a border area onthe outside edges of the paper is unavailable for printing when inHP LaserJet Emulation mode. This space is approximately 0.17inches (4.2 mm) on each side, as shown in figure 2-1. Theshaded area shows the image area.Figure 2-1. Image areaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaFor envelopes with HP PCL, there is a border area ofapproximately 0.27 inches (7 mm) on the edge toward the frontof the printer, as well as 0.17 inches (4.2 mm) along the otherthree edges, as shown in figure 2-2.Figure 2-2. Envelope and post card edge deletion areaFeed edgeaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaPost cardDeletionareasFeed edgeaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaEnvelopeaaaaaaaaaaaaDeletionareasFontsThe printer implements the internal font set of the HP LaserJetIIISi. For information on fonts, refer to the Xerox MRP Family4220/MRP, 4230/MRP Operator Guide.Downloading fontsIn addition to the supported fonts listed in the operator guide,the printer can download other bitmap and scalable fonts.Scalable Intellifont soft fonts and TrueType fonts are supported.Downloadable fonts that are made permanent (E*c5F) ortemporary (E*c1F) are not listed on the Font Report, and cannotbe stored on the optional hard disk. Permanent fonts remain inmemory until you power off the printer or delete them.N Note: If you are running a 4220 product using a software versionlower than V1.54, PCL fonts cannot be stored on flash ROM.XEROX MRP FAMILY PCL 5 AND POSTSCRIPT PRINTER LANGUAGE REFERENCE 2-7