Xerox 6204 Installation Manual

Also see for Wide Format 6204: User guide User guide Setup guide User guide Release note

Contents

Xerox 6204 Installation Manual Manual pdf 6 page image

2 Xerox FreeFlow Accxes Drivers & Client Software Installation Guide8. Using the keyboard, enter the Name or IP address assigned to the printer. Click Next.9. Accept the Device Type=Standard Generic Network Card. Click Next.10. Click Finish.11. Click Close.12. Click Close.HP-GL/2 Driver Installation1. Go to the Printers FolderFor Windows 2000: Select Start > Settings > PrintersFor Window 2003 or XP: Select Start > Control Panel > Printers and FaxesDouble-click on Add Printer. Click Next.2. Select Local printer. Uncheck “Automatically detect and install my Plug and Play printer.Click Next.3. From “Use the following port:” Choose the port you created for this printer. Click Next.4. When asked for the printer manufacturer and model, select the Have Disk… button. Thenselect the Browse… button and navigate to the directory where the driver has beenunzipped and select the .INF file that corresponds to your printer.5. Select the printer you wish to install and follow the instructions.6. If the “Use Existing Driver” screen appears, select “Replace Existing Driver” and clickNext.7. If this is a server install, share the printer and give it a share name.8. Reboot the system.9. Enable or disable bi-directional support in Device options using the checkbox.The control for bidirectional support is located on the Device Options tab of the PrinterProperties. If Enable bidirectional support is checked, the driver will automaticallycommunicate with the printer and set the installed media size, finisher type, and Accxesfirmware version. If Enable bidirectional support is not checked, the user must be aware ofthose settings and make sure the driver settings match the printer settings.(Refer to the Xerox Wide Format FreeFlow Accxes Driver Release Notes for file names anddirectory structures of the installed driver.)To change the display units, select the printer icon from the Printers Folder. Choose File >Properties. Select the Device Options tab. Change the "Display Units" control to yourpreference. The currently used Firmware Revision is also listed on the Device Options tab.