Xerox DocuPrint 180 Configuration Manual

Also see for DocuPrint 4850 NPS: Message guide Installation planning guide System overview guide Specifications Troubleshooting guide

Contents

Xerox DocuPrint 180 Configuration Manual Manual pdf 107 page image

SETTING SYSTEM DEFAULTSXEROX DOCUPRINT NPS GUIDE TO CONFIGURING AND MANAGING THE SYSTEM 5-3Show Default MediaUse the Show Default Media command to show size, type, color, andweight for the default media.Access level Administrator, operator, userSyntax Show Default MediaArguments NoneExample This example shows the output of the Show Default Mediacommand:Setting feeder tray attributesThe Set Tray command (administrator or operator level) allows youto specify what type of media is loaded in your printer feeder trays.You must use the Set Tray command whenever you change themedia in a tray. You can also match the attributes of one tray to thoseof another tray.Note: The Set Tray command and related commands cannot beused for a tray that is being used by the current job, or while the IOTis warming up.For instructions on loading feeder trays, see “Loading paper” in theGuide to Performing Routine Maintenance.Set Tray and Set Tray DefaultUse the Set Tray command to specify what type of media is loadedin your printer feeder trays.Before using this command ensure that all trays are in the feedposition.Note: If you do not indicate the color or weight, the system uses thevalues of the default media.Access level Administrator or operatorPS-op>show default mediaSite default medium is USLetter::white:75