Xerox DocuPrint 75 Installation Planning Manual

Also see for Docuprint 75: Getting started Software guide Planning guide Supplementary guide Software guide

Contents

Xerox DocuPrint 75 Installation Planning Manual Manual pdf 23 page image

Installation Planning Guide Safety notesDocuTech/DocuPrint 75/90 and DocuPrint 75 MX 2-11• A wall panel circuit breaker, fuse, or other safety device hasbeen tripped.• Liquid is spilled into the equipment.• The equipment is exposed to water damage or flood.• Any part of the equipment is physically damaged.NOTE: The only method to remove all power from the printer isto disconnect the power cable from the electrical outlet.Printer - ozone informationThis product produces ozone during normal operation. Theozone produced is dependent on print volume and is heavierthan air. Install the system in a well ventilated room with theminimum cubic size requirements listed below. Providing thecorrect environmental parameter will ensure that theconcentration levels meet safe limits.The minimum cubic volume requirement is: 1,765 cubic feet (50cubic meters).To determine if the room has the required volume to meet theozone requirement, the length of the room multiplied by its widthand height should be equal to or greater than the cubic volumelisted above.If you need additional information about ozone, please requestthe Xerox publication Ozone (part number 610P64653) by calling1-800-828-6571 in the United States and Canada. In XeroxEurope countries, call the local welcome center.Printer - laser safetyCAUTIONThe use of controls, adjustments or performance of proceduresother than those specified in this guide may result in hazardouslight exposure.This equipment complies with international safety standards andis certified as a Class 1 Product.