PRINTER SPECIFICATIONS AND REQUIREMENTSXEROX DOCUPRINT 92C IPS INSTALLATION PLANNING GUIDE 6-5Space requirementsYou should consider the following factors when deciding where toplace the printer hardware components:• Adequate work space and service clearance around theequipment• Proximity to electrical and network connectors• Security of the work area. You may need to place the system inan area where you can restrict access to it. This may beimportant if your personnel need to print confidential documentsor if you are concerned with unauthorized usage.Dimensions and weights of the printer components are listed in thissection, along with diagrams, to help you visualize the sizes and totalspace requirements.! Warning: The printer controller must be positioned within the line-of-sight of the printer for safety purposes while servicing theequipment.Note: There must be a 78-inch / 198-cm vertical clearancethroughout the entire area. In addition, your printer must be installedin a fixed location with a minimum clearance space of 36 inches /91.4 cm around all sides of each piece of equipment for access byservice personnel.For information on clearance space and other space planningconsiderations, refer to the “Space planning guidelines” section ofthis chapter. Contact your service representative if you havequestions not specifically addressed in this guide.Printer placementThe following configurations are available for your Xerox DocuPrint92C printer:• Standard (two-tray) feeder with dual stacker• Standard (two-tray) feeder with stitcher/stacker• High-capacity feeder (HCF) with dual stacker• HCF with stitcher/stacker.Note: Additional space (6-inch by 64-inch / 15 cm by 163 cm) isrequired in front of the printer for CCU changeout cartoperability.!
